Windows 8 l2tp vpn client

If the VPN server accepts your name and password, the session setup completes. As a result, the L2TP layer doesn't see a response to its connection request. There will be a long delay, typically 60 seconds, and then you may receive an error message that says there was no response from the server or there was no response from the modem or communication device.

If you receive this error message before you receive the prompt for your name and password, IPSec didn't establish its session. If that occurs, examine your certificate or preshared key configuration, or send the isakmp log to your network administrator.

Many small networks use a router with NAT functionality to share a single Internet address among all the computers on the network. Home networks frequently use a NAT. For more information, see the "NAT Traversal" section. If the connection fails after you receive the prompt for your name and password, the IPSec session has been established and there's probably something wrong with your name and password.

Select the Enable software compression check box. Select the Security tab. From the Data encryption drop-down list, select Require encryption. Click Advanced settings. The Advanced Properties dialog box appears. In the Key text box, type the pre-shared key for this tunnel. Make sure the Verify the Name and Usage attributes of the servers certificate check box is selected.

Make sure you have imported the certificate to the client device. Do not change the default settings on the Networking tab. Click OK. Before you begin, make sure the client computer has an active connection to the Internet.

In the Windows notification area System Tray , click the Network icon. A list of available networks and VPNs appears. Select the VPN connection. You can access to any local servers and workstation on the destination network. Table of contents 1. Initial configurations only once at the first time 2.

Connect to the VPN Server 3. Enjoy VPN communication. Initial configurations only once at the first time Right-click the network icon on the bottom-right side of Windows screen, and click "Open Network and Sharing Center".

Click "Set up a new connection or network" on the "Network Sharing Center". Select "Connect to a workplace". If the username and password prompting screen appears, input both username and password field. You should check "Remember this password".